Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Strain Gauge in For...Next


JohnTr Aug 8, 2011 09:23 PM

Can I put an AVW200(...) statement in a For...Next loop. We have a CR800 with AVW200 and AM16/32B connected to 16 ST4 strain gauges.

So far I am only getting a reading on the first SG when using the For...Next loop. If I do not use a loop I get good readings on all my Strain Gauges.

* Last updated by: JohnTr on 8/9/2011 @ 12:14 PM *


JohnTr Aug 9, 2011 06:16 PM

I figured out my problem. Had an array dimensioned incorrectly.

Log in or register to post/reply in the forum.