Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CF CARDS


sudheex May 24, 2011 03:53 PM

HI...

we are using 9 dataloggers (CR10000) with network module and CFcard in the site to collect the measurements. It is noticed that the CF card that we using have many troubles like
1. error light eluminates(yellow).
2. programming of datalogger takes very long as usual
3. card cannot detected


So I would like to know do you peoples had any problems while using the CF card in the datalogger (CR1000), and do there is any specified CF card has to use.

Am using CF card of transcend 2GB.


Thank you
Sudheesh


aps May 25, 2011 12:41 PM

We have tested Transcend cards recently in our loggers and they did not operate reliably or as fast as the normal cards we recommend.

Please contact your local sales office for Campbell Scientific to get best advice on the cards to use. The industrial grade cards we sell have been tested in our products and confirmed to work, whilst many you can buy may either not work at all, or reliably in the long term with Campbell loggers.

Log in or register to post/reply in the forum.