Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR1000 does not answer Loggernet Call


CTS Jul 25, 2010 10:06 AM

Hi,
I am using a MC35i GSM modem to call a CR1000 logger. Connection is as follows:
1)black SC12 Rev 1 cable connected to CS I/O port of CR1000
2)SC923A connected to black cable (Logger side)
3) DIY Y Rs232 cable to minitor comms between SC923A and GSM modem. Y cable is tested and working. Monitoring PC cannot interfere with RS232 coms.
The modem settings are as follows:

ACTIVE PROFILE:
E1 Q0 V1 X4 &C1 &D2 &S0 \Q0
S0:002 S3:013 S4:010 S5:008 S6:000 S7:060 S8:000 S10:002 S18:000
+CBST: 7,0,1
+CRLP: 61,61,78,6
+CR: 0
+FCLASS: 0
+CRC: 0
+CMGF: 0
+CNMI: 0,0,0,0,1
+ILRR: 0
+IPR: 9600
+CMEE: 1
^SMGO: 0,0
+CSMS: 0,1,1,1
^SACM: 0,"000000","000000"
^SCKS: 0,1
^SSET: 0
+CREG: 0,1
+CLIP: 0,1
+CAOC: 0
+COPS: 0,0,"CC 649 NC 03"
+CGSMS: 3

When I dial from loggernet I can see the modem is ringing on RS232 but the logger does not answer.

Auto answering is set to 2 rings (ATS0 =2)

Should I configure the logger first via RS232 to accept incoming calls from a GSM modem?

thx a mil
Erik


aps Jul 26, 2010 11:14 AM

There is no configuration needed in the logger to allow it to answer incoming connections on the COM ME port.

To resolve this probelm I would check out your RS232 cable making sure the DTR line to the modem is connected. I would also disable handshaking in the modem. (Not sure if you have as we do not officially support that modem)

When you say it does not answer, if you dial the data number for the phone is the called answered and you hear modem negotiation tones, or does it ring out?


MCTT Dec 1, 2011 01:25 PM

Hi,

I have met the same issue.

This is Logtool file

Please see the file enclose.
Link to download file (http://www.mediafire.com/?wdadm3kh4ln9kf6)

However, I use the command AT&D0 to Disable DTR and call between base phone and remote phone via hyper terminal , it work ok, but It still does not work.

Log in or register to post/reply in the forum.