Does anyone have the dimensions for the NL100 mounting holes?
From looking at the one on my desk... there are four mounting holes. Horizontally they are spaced 8.75" center to center; vertically they are spaced 2". There are also two additional holes on a rolled top edge of the case that are also 8.75" center to center.
Of course, you have to trust I can read a ruler correctly ;)
Hope this helps.
Dana
Thanks,
If I understand this correctly, this will not fit the pre-drilled panel?
According to the mechanical drawing for the case, the holes are spaced 2" by 9" centre to centre. I believe that this will match the pattern on the pre-drilled panel.
I'd better replace my ruler :)
Dana
I've got a couple of them mounted on the standard mounting panels, so I have to believe it works...