Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

E20 Pyranometer equal to CS300 Pyranometer?

AlexChao Nov 5, 2009 06:00 AM

Dear Sir

I have E20 Pyranometer sensor,and want to measeur with CR1000,but I have CS300 user manual.
Please tell me command of CS300 read E20 sensor?

Best Regards

sonoautomated Nov 6, 2009 11:28 PM

Alex,

You can use either instruction; VoltDiff or VoltSE. If it's an older sensor you will want to make sure its been calibrated for more accurate measurements.

Regards

* Last updated by: sonoautomated on 11/3/2010 @ 7:56 AM *

MCTT Nov 8, 2009 02:58 PM

Alex,

I have done a few projects about Pyranometers,

Please send me E20's catalog and CS300 's user manual,

I will help you to programming it.

BRs,
Nguyen Van Hung
--------------------------------------------
Measurement and Control Equipment Co., Ltd

MCTT Nov 8, 2009 02:58 PM

This is my mail:

nvhung.mctt@gmail.com

ariffu Nov 3, 2010 07:47 AM

I also have CR1000 data logger and E20 pyranometer jauntering.
E20 Jauntering only have two cable output.
sensitivity : 48uV/W/m^2
Linierity : max deviation of 1% up to 3000 W/m^2
Accuracy : 3%
spectral range : 400 - 1100 nm
response time : typical 2uS

could you help me to configure the CRbasic
Tq

Ariffudin

Log in or register to post/reply in the forum.