Hi again,
I get an error when using Shortcut to write a simple program for measureing a Gill Windsonic (Option1) RS-232 sensor. The error says there is an "Undeclared Variable h0Dh0A" and "Variable illegal in Parameter: h0Dh0A". Any thoughts?
Thanks,
Larry Treadaway
I found and fixed the error. in the line as follows:
SerialInRecord(Com1,WSStr,&h02,0,&h0hD0A,ByteRet,00)
the error was in the end word section of the statement, &h0hD0A, should read &h0D0A. Then it complies without any problem. I found another forum entry from 2011 and 2009 indicating this same problem with Shortcut. I am running LoggerNet 4.1 but perhaps there is an updated Shortcut where this error is fixed.
Thanks,
Larry
I believe this was resolved in the Sensor Pack release in March 2012.
You can find a link to that download here:
https://www.campbellsci.com/scwin
Dana
Thanks Dana, much appreciated.
Larry