Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

how to config Ethernet network

TaCaPica Feb 14, 2012 01:20 PM

I there

I need to config a network of loggers based on ethernet. I have 3 CR1000 with NL115.

Because of security issues i have 2 of them "dumping" information in the third. I have to do this every second.
In my lab tests after just a few seconds of work, the network goes dead and i have to disconnect the loggers from the network to link myself to them (even with device config utility!)

Can anyone help me?

Thanks a lot

GaryTRoberts Feb 14, 2012 04:05 PM

If I could have a little more information, that would be helpful. Are you using OS 24 in the loggers? Also, is the network independent (only the three dataloggers are on it)? What are you using to pass the data back and forth (FTP, PakBus, etc.).

Thanks.

-Gary

Log in or register to post/reply in the forum.