Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

sync time between loggers


meteor Jan 9, 2012 02:13 PM

Is it possible to sync the time between two CR1000 data loggers?

I can't connect a computer with LoggerNet. At the site i have not enough power.

Both loggers measure high frequently and the time on each logger should be exactly the same.

Greetings
Uwe (Germany)


aps Jan 9, 2012 02:29 PM

With the dataloggers connected together over some form of serial/pakbus link you can sync one to the other using the Clockreport and PakbusClock instructions in the loggers (See the CRBasic help).

IF the connection is over IP, then you can use the NetworkTimeProtocol instruction where one logger acts as a time server, as outlined in another thread recently.


meteor Jan 10, 2012 06:23 AM

Thank you very much!
These instructions i had overlooked. I try out it immediately.

Log in or register to post/reply in the forum.