Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

What is CR200 instructions as BrHalf for CR1000?

AlexChao Dec 13, 2011 02:40 AM

Dear Sir

I had a sensor measured by CR1000 instruction Brhalf(ex BrHalf(TTValue,1,mV2500,5,Vx3,1,2500,True,0,250,10,0)) before,but I want to use CR200 to measure that now.Please how to edit CR200 instruction into CR2 File???

Thanks

JDavis Dec 16, 2011 12:50 AM

Look at the ExDelSE instruction.
The output is different, so you will need to adjust the multiplier.

The output of ExDelSE is in millivolts. The output of BrHalf is (millivolts of signal)/(millivolts of excitation).

Grant Dec 16, 2011 12:56 AM

ExDelSE(TTValue,1,1,Ex1,mV2500,500,1.0,0)

Log in or register to post/reply in the forum.