I have an old CR10 and SM192 that I acquired and would like to deploy it to measure a couple of single ended voltages. I'd like to use the SM192 module so it'll retain the program and data between battery changes. So far I have been able to successfully program the CR10 with ShortCut to sample the 2 single ended channels and write it to a table. But how do I make sure the program and data is being written to the SM192 and not just the onboard CR10 memory?
The latest and all previous versions of Shortcut that I can recall automatically put instructions in the logger program to output data to an SM192/716. The logger checks every 10s to see if an SM is present, if one is there the data is stored to it, if not the program runs as usual.