FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1646 total: showing 1501-1520)

How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU server?
Is it possible to overwrite an existing array using a CR850?
Can the NL201 be put into bridge mode via the settings of a CR800 or CR850?
Can the CR850 be programmed to show information in the display without using the keyboard?
Can a new program be installed on a data logger using a laptop and PC200W?
When no excitation is commanded, are the voltage excitation ports on the data logger isolated from the data logger ground?
Instead of saving the data of a CRBasic data logger to one large file, how can it be saved in daily, hourly, or half-hourly files?
If a computer does not have any serial ports, how can software (such as LoggerNet, PC400, PC200W, or Device Configuration Utility) talk to the data logger?
Can external devices be switched on and off using a data logger?
If a device or sensor is not available for selection in the Short Cut program, how can it be added?
Can the data logger be damaged by wiring the sensors to the wrong ports?
How can a floating point value be cast as a long integer?
How can data that has been transmitted from a data logger to LoggerNet then be transmitted to a webhost that displays the data graphically?
Is there a way to only record measurements during the daytime and put the data logger in sleep mode during the nighttime to conserve power?
What is checked during the calibration of a Campbell Scientific data logger?
Is it possible to use LoggerNet Admin software to connect to, and display data from, multiple data loggers?
Can a data logger be contained in a waterproof enclosure?
What does the PreserveVariables instruction do?
Can more than one SDM device be connected to a data logger?
Can Campbell Scientific data loggers be used with a telemetry system to remotely download data, check parameters, etc.?

Previous Next